KME Diego G3 - Error Codes and Flashing Patterns

Page 5 / 8
ver. 1.3.2 04-12-2019
KME Sp. z o.o.● ul. Św. Teresy od Dzieciątka Jezus 103A● 91-222 Łódź● Office: Aleksandra 24/26 93-418 Łódź ●
tel +48(42) 611 00 26 ● fax +48(42) 611 82 52 ●
www.kme.eu ● NIP: 732-199-00-33 ● REGON: 473207460 ●
Nr KRS: 0000181402
ECU, and most of them are indicated on the control panel. Errors are indicated by alternate
flashing of the red and blue LEDs with an acoustic signal. In NEVO system errors are
additionally indicated by flashing the gas level LEDs (only when this option is activated). The
most common cause of the error signal is no gas in the tank. Deleting this alarm requires
pressing the fuel type selection button or it will be muted automatically after a few seconds.
2.3.1 Errors flashing codes (NEVO and NEVO-SKY only)
NEVO error codes list (code, description, flashing code):
Control panel type
NEVO DG4
NEVO DG5 / DG7
Code
Description
Red Green Green Green
Diode 1
Diode 2
Diode 3 Diode 4 Diode 5
E001-
E008
Petrol injector no signal cyl 1..8.
E009-
E016
Gas injector malfunction cyl 1..8.
E017
Reducer temperature sensor short.
E018
Reducer temperature sensor open.
E019
Gas temperature sensor short.
E020
Gas temperature sensor open.
E021
Gas valves – circle short.
E022
Gas valves - circle open.
E023
Empty gas tank (low gas pressure).
E024
Inefficient reducer heating circle (Reducer too cold
<15°C).
E025
Petrol injectors merged (lack of information about
mixture).
E026
Gas injectors merged (lack of possibility of gas
mixture correction).