Diaphragm pump N96 Installation and connection
Translation of Original Operating and Installation Instruction, English, KNF 316836-316838 01/20
13
7 Installation and connection
Install the pumps only in accordance with the operating parameters and
conditions described in Chapter 4 Technical data.
à
Observe the safety instructions (see Chapter 3 Safety).
DANGER
Risk of dangerous gas mixtures during pump op-
eration
Depending on the medium being transferred,
breakage of the media-contacting components
can result in a dangerous mixture if the medium
mixes with the air in the compressor housing or
the surroundings.
à Before using a medium, check the compati-
bility of the media-contacting components
(see 4 Technical data) with the medium.
7.1 Installing the pump
à
Store the pump at the installation site prior to installation to bring it up
to the ambient temperature.
CAUTION
Risk of injury from freely rotating shaft end
Touching the pump at the end of the shaft may re-
sult in injury through burning and crushing.
àTake protective measures to safeguard
against touching moving and hot parts.
àWear appropriate personal protective equip-
ment if necessary.
CAUTION
Risk of injury from sharp edges on motor
There is a risk of injury from cutting on the sharp
edges when grabbing the pump on the motor.
à Where appropriate, wear suitable personal
protective equipment (e.g., safety shoes,
safety gloves).
Mounting dimensions
à
For mounting dimensions, see the following illustrations:
To Next Page
Loading...
