KNIPEX BiX - Replacing the Cutting Blade

OpEraTiON
7 Status: 13.10.21
4.2 Replacing the blade
4.2.1 Remove the used blade
» Remove the blade block as previously described.
» Use a screwdriver to slide the spare blades out of the tool.
» Take out a spare blade and push the second back into the tool.
» Reinstall the blade block with the blade facing out.
» Close the tool and screw down the blade block.
Remove spare blades
» Loosen the screw to secure the retaining plate and remove the retaining
plate and the old blade.
Caution: The blade is sharp!
< 1 Nm
2.
1.
3.
Remove the blade
» Dispose of the used blade properly.