10
ASSEMBLY INSTRUCTIONS
This product requires assembly.
WARNING
• Always remove the battery pack from the
product when you are assembling parts, making
adjustments, cleaning, or when the product is
not in use.
1. Unfolding the Shaft
WARNING
• In order to avoid pinching your hands or ngers,
do not hold the shaft at the joints.
• Do not attempt to start the trimmer until the shaft
has been locked.
a. Remove the battery pack from the trimmer.
b. Put your trimmer on the ground and carefully
unfold the shaft. Make sure that the cable
inside the shaft will not be pinched when
closing the hinge (D).
c. Use a Phillips screwdriver (not included) to
secure the shaft in locked position with two
screws (O).
2. Mounting the Guard
WARNING
• To reduce the risk of injury to persons, never
operate without guard in place. The guard must
always be on the tool to protect the user.
• Always wear gloves when mounting or replacing
the guard. Be aware of the line-cutting blade on
the guard and protect your hands from being
injured by the blade.
a. Remove the battery pack from the trimmer.
b. Lift the cutting head unit (F) so that the bump
head (G) is facing upward; align the groove
on the bottom of the guard (L) with the raised
portion on the base of the trimmer gear case
(P), and then slide guard onto the base as
shown (Fig. 2a).
1a
D
1b
O
PUSH
2a
L
P
F
G
To Next Page
Loading...
Need help?
General