18
Printed in China
TROUBLESHOOTING
WARNING
• Turn the switch to the “OFF” position and remove the battery pack from the circular saw before
performing troubleshooting procedures.
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
The circular saw does
not work.
Battery is depleted. Charge the battery.
Blade binds, jams, or
burns the wood.
1. Improper operation.
2. Dull blade.
3. Improper blade.
1. See “OPERATING
INSTRUCTIONS” section.
2. Replace or sharpen blade.
3. Replace blade.
Saw vibrates or
shakes.
1. Improper blade.
2. Improper operation of
installing blade.
1. Replace blade.
2. Remove the blade and reinstall it,
ensuring no part was missed.
The LED worklight
blinks rapidly.
The tool has stopped
working to protect internal
circuits.
Release the trigger switch, wait for
the tool to cool down, then and start
the tool again.
The LED worklight
blinks slowly.
The battery charge is very
low.
Charge the battery.
WARRANTY
For 5 years from the date of purchase, the circular saw is warranted for the original purchaser
to be free from defects in material and workmanship. This guarantee does not cover damage
due to abuse, normal wear, improper maintenance, neglect, unauthorized repair/alteration, or
expendable parts and accessories expected to become unusable after a reasonable period of
use.
If you think your product meets the above guarantee criteria, please return it to the place of
purchase with valid proof of purchase and the defective product will be repaired or replaced at
no charge. This guarantee gives you specic legal rights, and you may also have other rights
that vary from state to state.
To Next Page
Loading...
Need help?
General
