KIMA00H1 (0204)
17
2.8
Wiring
It is the compressor owners responsibility to insure a safe installation
that complies with applicable local codes and the National Electrical
Code (N.E.C.). This includes properly sized short circuit and ground
fault protection, power connection wire sizing, and equipment
grounding.
The compressor unit is available with many motor, starter, and
sequence control options. Therefore, the wiring schematic provided
with the assembly must be consulted. Be sure the motors are wired
for the proper voltage and agree with the plant power system.
The compressor is equipped with a programmable controller to
automatically control the starting, operating, and stopping sequences.
This controller also monitors critical parameters during operation and
provides for protection of the machine in the event of a problem.
Carefully read Section 5, Electrical Controls, for a description of the
standard controls. For custom control schemes a separate
“Description of Operation” is provided with the electrical schematic.
To Next Page
Loading...
Need help?
General
