Troubleshooting
33
■
If a trouble or disorder occurred in the product, please check the following points.
Trouble
Check Points
- Is noting displayed in the screen?
- Isn't the screen clear?
- Is the screen dim?
- Isn't the color matched?
- Are black lines shown in the camera
image screen?
- Check that the power is normally connected to the constant voltage
adaptor (DC12V/500mA).
- Check that the video signal is normally connected.
- In case VIDEO (DC) lens is used, check that the selection switch for
automatic lens are properly set at DC/VIDEO.
- Check that lens is stained with alien substances or dusts.
- Check the monitor state.
- If too much bright lays are infused into the camera under the present
installation angle, please adjust such angle.
- Readjust the back focus of camera.
- Adjust the monitor state.
- If automatic iris lens is used, properly adjust the brightness of the lens.
- Check whether "WHITE BAL." is properly set in functional setup.
- Check the adaptor connected to the camera.
(Check that there is no problem in rated voltage).
34
Trouble
Check Points
- Does not the motion detection work?
- Is there a flicker on the screen?
- Is Line Lock mode setup unavailable?
- Doesn't COLOR (day & night) work?
- Doesn't SENS UP work?
- Check whether MOTION DETECTION function is set as "OFF"?
If so, set the function as "ON."
- Is MD LEVEL set too low?
- Is MD AREA set appropriately?
- Is camera lens directed to the sun or fluorescent lamp?
- Check the installation angle of camera.
- If DC12V/300mA is used, Line Lock function doesn't work.
- Check whether "AGC" is set as "OFF." If so, change the state of
AGC to "ON."
- Check whether "AGC" is set as "OFF."
If so, change the state of AGC to "ON."
- Check whether SHUTTER is set as "MANUAL."
If so, change such mode to ESC.
To Next Page
Loading...