Kodak 550 - Advanced Slide Handling; Removing the Slide Tray; Skip Projection; Showing Single Slides

12
REMOVING SLIDE TRAY
With the projector turned on. you may remove the slide
tray quickly by depressing and holding the SELECT but -
ton; at the same time . rotate the slide tray until the
identification number "0" is opposite the gate index on
the projector. Release the select button and then lift off
the slide tray.
SKIP PROJECTION
Depress and hold the SELECT button ; then rotate the slide
tray until the number of the slide you wish to project is
opposite the gate index on the projector . Release the
select button; the selected slide will be immediately pro -
jected . This permits your showing any individual slide out
of sequence.
EDITING SLIDES-SHOWING SINGLE SLIDES
WITHOUT SLIDE TRAY
If this is the first time yo.u have viewed the slides. you
may want to edit them as you load them in the slide tray.
or you
may wish to show single slides.
Set the automatic ti mer on MANUAL. Insert a slide.
correctly oriented . into th e slide mech a nism . Push the
slide down into the mechanism as far as it will go . After
viewing the slide. depress the SELECT button ; the slide
will be ejected from the gate . Slides of any make or
thi ckness can be shown by this method.
NOTE: If you wish to use an extra slide. for continuous-
repeater operation . or a title slide (one is furnished) in-
sert the slide into the gate before putting the slide tray
in position . If you want the screen to be dark after you
have
shown a tray of slides. insert a 2 x 2-inch piece of
thin cardboard into the gate before putting on the slide
tray . The slide or piece of cardboard will enter the blocked-
off space in the slide tray during projection and be re-
turned to the gate when the slide tray is removed .