Kodak 550 - Slide Tray Management; Loading the Slide Tray

SLIDE TRAY
Furnished with the projector is a slide tray that holds
80 slides. The tray accepts 35mm (24 x 36mm). 828
(28 x 40mm). and 1% x 1%-inch slides in cardboard .
glass.
metal. or plastic mounts of 1/10 inch thickness
or less. Slides mounted with loose or sticky tape or mounts
that have sharp glass corners are not recommended for
use in the slide tray. Slide-identification numbers are
molded onto the tray . As the tray revolves. the number of
the slide being shown will be opposite the gate index
on the projector.
LOADING SLIDE TRAY
Check to be sure that the LOCK on the bottom of the
tray is engaged in the NOTCH in the metal slide-retainer.
If it is not. turn the retainer until the lock engages the
notch in the retainer.
Remove
the lock ring from the top of the tray by turning
it in the direction of the arrow marked UNLOCK; then lift
off the ring. Insert a slide in each open slot in the tray.
with the top of the picture down and the bordered side
of each cardboard-mounted slide (or the emulsion side
of a glass. metal. or plastic-mounted slide) facing toward