Kodak 550 - Post-Show Procedures; After the Show Steps; Projection Lamp Replacement

SELECT BUTTON
Depress and hold the SELECT button , at the same time
rotating the slide tray in either direction to align with
the gate index the identification number of the particular
slide you wish to show . When you release the button the
selected slide will be " on the screen." Depressing the
select button provides instant "editing" of the projected
slide.
AFTER THE SHOW
1.lf automatic slide-changing is being used, turn the auto-
matic timer to MANUAL.
2. Remove the slide tray (identification number " 0" at
gate index).
3. Depress the FAN button : allow the fan to run until the
projection lamp has cooled: then depress the OFF button.
4. Unplug the power cord. Fold the cord by putting the
two ends of the cord together and folding it in about 5-
inch lengths . Replace it in the cord compartment . Unplug
and replace the remote control (if used).
5. Lower the projector by turning the ELEVATE knob
counterclockwise .
6. Turn the FOCUS knob counterclockwise to retract the
lens.
CARE OF THE PROJECTOR
WARNING : After use. always make sure that the power
cord is disconnected and that the projection lamp has
cooled
sufficiently before attempting to disassemble the
projector for cleaning or lamp replacement . Cooling can
be accelerated
by running the fan with the lamp turned
off: just depress the FAN button .
PROJECTION-LAMP REPLACEMENT
Remove the OPTICS COVER by turning the cover screw
toward the back of the projector until the cover can be
removed from the projector . Remove the lamp by pulling
it st ra ight out .
To install a
lamp . place the center p ost of the lamp in
13