5-4 October 2020
Troubleshooting
Clearing a Paper Jam
If a Paper Jam message appears on the software operator control
panel, follow this procedure. If a paper jam occurs in the slitter, or
Paper Jam 70 -79 appears on the software operator control panel,
see “Clearing a Slitter Jam from the 6950 Printer” on page 5-8.
1. Move the power switch to the Off ( ) position.
2. Remove the exit tray (if installed).
3. Remove and empty the trim tray. See “Removing the Trim
Tray” on page 2-6.
4. Clear any debris from the exit.
To Next Page
Loading...
