Installing the Unit
6–4 INSTALLING THE UNIT
Installing the Unit
Before installing the Unit, check that you have:
• All the necessary tools
• All the cables
• All the switches
Installing the Column
To install the column, follow these steps:
1. While the column is still on the floor, in a horizontal position, fit the wall bracket lips
inside the column and tighten the 2 screws. If necessary, attach the column to the steel
base plate at this time.
2. Connect the following wiring in the column connecting terminal (8):
• Unit mains connecting terminal (6)
• Green lamp x-ray emission indicator (7)
• X-ray remote control (10)
• Door safety switch (9) (optional)
• Ethernet outlet (12)
Depending on the standards in force in your country, we recommend that you also provide
the door safety switch (10).
2
6 7 9 10 12
8
RJ45
6 mm
x2
To Next Page
Loading...