Installing the Unit
6–6 INSTALLING THE UNIT
Installing the Head
To install the head, follow these steps:
5. Remove the head cover by unscrewing the 4 screws that attaches the head cover to the
head chassis.
6. Remove the restraining screws securing the Head to the transport trolley (A).
7. With the help of 3 persons, grasp the Unit head, mount and position it on the hook of the
column sliding unit (A). Screw, but do not tighten, the 2 upper screws with washers (B).
8. Release the Unit rotating arm by removing the transit locking screw (C) that passes
through the CJ 653 board. Place the screw in the chassis, so that it can be retrieved quickly
if the Unit is dismantled at a later date.
5
6
A
A
6
5 mm
3 mm
x4
x2
x2
To Next Page
Loading...