Kodak 9000 - Acquiring a 3 D Image

Installing the Unit
KODAK 9000 3D Extraoral Imaging System_Installation Guide (SM711)_Ed 01 6–
9. Rotate the Unit rotating arm by hand. Screw, but do not tighten, the 2 screws with washers
located under the Unit head (D).
Relieve the weight of the head at the front with the help of 1 person. Check that the head is
correctly positioned using a spirit level (E). Tighten the 2 upper (B) and the 2 lower (D)
screws with washers of the head assembly.
The column is ready for the fixed arm attachment.
C
9
A
A
C
8
7
B
D
6 mm
x2
x1
x2
E