Kodak CAROUSEL 4600 - Changing the Projection Lamp

Maintenance
Changing the Proiection Lamp
Slide the power switch to Off and unplug the projector.
Allow the projector and lamp
to cool for about 10 minutes.
Push the lamp-module
release button and remove
the lamp module.
Note:
There is an additional
safety latch,
which reduces the
chance
of an accident with a
loosely inserted lamp module,
that may cause some resistance.
To release the latch, you may
need to apply extra effort when
you
pullout the module.
Lift up the
lamp release clip. Carefully remove the worn lamp from the
socket and place it on a heat-resistant surface.
Insert a new lamp
into the socket.
Push down to tightly
seat the replacement
lamp.
Relatch the
clip in the
forward position and
push the lamp module
all the way back into
the projector until
it latches.
KODAK CAROUSEL® Slide Projector
Lamp release clip
21