Kodak Carousel 850H User Manual

POWER CORD
REMOTE-CONTROL
CORD
Remove POWER CORD and REMOTE-CONTROL
corp from cord compartment (on under-
side of projector). Plug remote-control
cord into rear of projector. Plug power
cord into 110- to 125-volt, 60 Hz power
outlet. See page 5.
Briefly push FORWARD BUTTON on projec-
tor or FOR (forward) button on remote
control to project first slide on screen.
See page 8.
GATE INDEX
Place loaded slide tray on projector with
TRAY INDEX BAR opposite GATE INDEX. See
page 8.
Rotate Focus KNOB until projected image
is critically sharp. Only this first slide re-
quires focusing if all slides are in same
type of mount. For auto-focus operation
with intermixed types of slide mounts,
see page 9 under “Focus.”
POWER SWITCH
Set AUTOMATIC-TIMER SLIDE at M (manual).
Slide power switcH to HIGH or LOW. See
page 8.
Briefly push forward button on projector
or on remote control to change slides.
For immediate projection of any slide in
tray, firmly press and hold down SELECT
BAR, rotate tray to desired slide number,
and then release select bar. See page 10.
AUTOMATIC-
TIMER SLIDE
FOCUS
KNOB
SELECT
BAR
BUTTON

Kodak Carousel 850H Specifications

General

Brand	Kodak
Model	Carousel 850H
Category	Projector
Language	English