Taking pictures and videos
www.kodak.com/go/support
13
Using optical zoom
Use optical zoom to get up to 3X closer to your subject. Optical zoom is
effective when the lens is no closer than 24 in. (60 cm) to the subject or
5 in. (13 cm) in Close-up mode. You can change optical zoom before (but not
during) video recording.
1 Use the viewfinder or camera screen to frame
your subject.
2 Press Telephoto (T) to zoom in. Press Wide
Angle (W) to zoom out.
If the camera screen is turned on, the zoom
indicator shows you are in optical zoom.
3 Press the Shutter button halfway and hold
to set the exposure and focus, then press the
rest of the way down to take the picture.
(When taking videos, press and release the
Shutter button.)
Using digital zoom
Use digital zoom in any Still mode to get an additional 5X magnification
beyond optical zoom. Combined zoom settings are from 3.6X to 15X in 0.6X
increments. You must turn on the camera screen to activate digital zoom.
1 Press the OK button to turn on the camera screen.
2 Press the Telephoto (T) button to the optical
zoom limit (3X). Release the button, then
press it again.
The camera screen displays the zoomed image
and the zoom indicator.
3 Press the Shutter button halfway and hold
to set the exposure and focus, then press the
rest of the way down to take the picture.
NOTE: You cannot use digital zoom for video recording. You
may notice decreased image quality when using digital
zoom. The blue slider on the zoom indicator pauses
and turns red when the picture quality reaches the
limit for an acceptable 4 x 6-in.
(10 x 15 cm)
print.
Optical zoom range
Digital zoom range
To Next Page
Loading...
Need help?
General
