Kodak EasyShare CX7220

Getting started
2
Loading the batteries
Two AA non-rechargeable starter batteries are included with your camera.
1 Make sure the Mode dial is set to Off (see
page 4).
2 On the bottom of the camera, slide the battery
door and lift to open.
3 Insert the AA batteries, as shown.
4 Close the battery door.
If you purchased an optional Kodak EasyShare
Ni-MH rechargeable battery pack (also
included with the Kodak EasyShare camera
dock or printer dock), insert it as shown.
If you purchased an optional Kodak CRV3
lithium battery (non-rechargeable), insert it as
shown.
AA
Ni-MH rechargeable
battery pack (optional)
CRV3
(optional)