Troubleshooting
35
Computer/connectivity problems
You cannot take a
picture
■ Turn the camera off, then on again.
■ Depress the Shutter button all the way (page 8).
■ Insert new batteries. If using rechargeable batteries,
charge before inserting (page 2 and page 3).
■ Wait until the ready light is green before attempting to
take another picture.
■ Transfer pictures to the computer (page 32), delete
pictures from the camera (page 21), switch image storage
locations (page 15), or insert a card with available
memory (page 7).
Picture orientation is
not accurate
■ Set the Orientation Sensor (page 18).
Flash does not fire
■ Check flash setting, and change as needed (see page 12).
Battery life is short
■ Wipe the contacts with a clean, dry cloth (page 3) before
loading batteries in the camera.
■ Insert new batteries. If using rechargeable batteries,
charge before inserting (page 2 and page 3).
Picture taken does not
appear as framed in
viewfinder
■ For best results (especially in Close-up mode or when
using zoom) use the camera screen to frame your subject
(page 10).
If... Try one or more of the following
The computer does
not communicate with
the camera
■ Turn on the camera.
■ Insert new batteries. If using rechargeable batteries,
charge before inserting (page 2 and page 3).
■ Make sure USB cable is securely connected on camera and
computer port (page 32).
■ Make sure the EasyShare software is installed (page 27).
Slide Show does not
run on an external
video device
■ Adjust the camera Video Out setting (NTSC or PAL,
page 18).
■ Make sure the external device settings are correct (see the
device’s user’s guide).
If... Try one or more of the following
To Next Page
Loading...
Need help?
General
