Getting started
www.kodak.com/go/support
2
Installing the custom camera insert
IMPORTANT:
Use the custom insert that came with your digital camera to dock the
camera, otherwise the camera may not fit on the printer dock.
■ Locate and install the custom insert included with
your camera.
IMPORTANT:
Depending on your camera connector, you
may also need to use the optional Kodak
dock adapter kit D-26.*
a Remove any packing material covering the
connector.
b Place the rear tabs of the insert in the slots
toward the back of the printer dock.
c Press the front of the insert down and snap into
place.
* Contact customer support for a dock adapter if it is not included with your product.
Visit www.kodak.com/go/dfiswwcontacts.
For Kodak EasyShare camera and dock compatibility, visit
www.kodak.com/go/adapterkitchart.
To Next Page
Loading...
