Troubleshooting
www.kodak.com/go/support
49
Picture orientation is
not accurate
■ Set the Orientation Sensor to ON (see page 32)
Flash does not fire
■ Open the flash unit (page 9).
■ Check the flash setting and change as needed (page 9).
NOTE: The flash does not fire in all modes.
Storage location is
almost or entirely full
■ Transfer pictures to the computer (page 44).
■ Delete pictures from the card (page 17) or insert a new card.
■ Change image storage location to internal memory (see
page 31).
Battery life is short
■ Make sure the correct battery type is installed (page 58).
■ Wipe the contacts with a clean, dry cloth before inserting a
battery in the camera.
■ Insert a new or charged battery (page 2).
You cannot take a
picture
■ Turn camera off, then on again. Make sure the camera is not in
Favorites mode. If prompted, set language and date/time.
■ Press Shutter button all the way (page 5).
■ Insert a new or charged battery (page 2).
■ Wait until the AF/AE indicator turns green before attempting to
take another picture.
■ Memory full. Transfer pictures to the computer (page 44), delete
pictures (page 17), change image storage location (see page 31),
or insert another card.
Error message appears
on EVF/LCD
■ Follow the EVF/LCD prompts.
■ Remove memory card from the camera.
■ Turn the camera off, then on again.
■ Remove the battery and wipe the contacts with a clean, dry cloth.
■ Insert a new or charged battery (page 2).
■ Get customer support help (page 52).
If Try one or more of the following
To Next Page
Loading...
Need help?
General
