Troubleshooting
www.kodak.com/go/support
51
Direct printing (PictBridge) problems
Picture is too light
■ Reposition camera to reduce the amount of available light.
■ Turn flash off (page 9).
■ Move so that the distance between you and the subject is within the
effective flash range (page 9).
■ To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator turns green, press the Shutter
button completely down to take the picture.
■ If using P, A, or S mode, adjust Exposure compensation (page 36).
Picture is not clear
■ To automatically set exposure and focus, press the Shutter button
halfway. When the AF/AE indicator turns green, press the Shutter
button completely down to take the picture.
■ Clean the lens (page 56).
■ Make sure camera is not in Close-up/Macro mode if you are more
than 27.6 in. (70 cm) from your subject. (Move further away if you
are using the zoom lens in Close-up/Macro.)
■ Place the camera on a flat, steady surface or use a tripod, especially
in high-zoom settings or in low light.
If Try one or more of the following
Cannot locate desired picture.
■ Turn on the camera. Make sure the camera is
accessing internal memory/card or Favorites.
■ If you are using Direct print, use the menu to change
the image storage location.
The Direct print menu interface
turns off.
Press any button to redisplay the menu.
Cannot print pictures.
■ Ensure that there is a connection between camera
and printer (page 44).
■ Ensure the printer and camera have power.
If Try one or more of the following
To Next Page
Loading...
Need help?
General
