Maintenance
User guide 37
Printhead Alignment
The printhead may need to be aligned to enable high-quality prints. The Kodak printer
automatically performs a calibration every time you install or replace a printhead. You can also
initiate a printhead alignment from the ESP 3 printer driver, Home Centre software or Control
Panel.
To align the printhead from the Control Panel
1 Load the paper tray with US letter or A4 Kodak plain paper.
2 On the Control Panel, press and hold Scan and Cancel at the same time until the On/Off light
starts blinking. The following pattern is printed.
To Next Page
Loading...
