Kodak i1220 User Manual

Kodak i1220 Scanner Installation and Configuration Guide Version: 4/3/2012
Page | 1
SCEIS Imaging: Kodak i1220 Scanner
Installation and Configuration Guide
If your scanner is already installed, go to the CONFIGURATION section on page 3.
Configuration will set the scanner to ignore blank pages.
INSTALLATION
TWAIN Driver Installation
1. Install the Kodak twain driver from the installation disk or download the most current driver version from:
http://graphics.kodak.com/docimaging/US/en/Products/Document_Scanners/Desktop/i1220_Scanner/Support/
Drivers_And_Downloads/i1200_Plus_Series_Scanner_Drivers/index.htm
The serial number of the scanner is required for the driver download. The serial number is located on the bottom of
the scanner.
Enable Citrix Access to the Scanner
2. Log in to Citrix (sceisgateway.sc.gov) and log in to either SAP or OnBase, it does not matter which one.
3. Right-click on the Citrix Connection icon in the system tray, located near the time in the lower right corner of the
screen. Left-click on ‘Open Connection Center’.
Click ‘Scanner Security’

Kodak i1220 Specifications

General

Brand	Kodak
Model	i1220
Category	Scanner
Language	English

Summary

Scanner Installation

TWAIN Driver Installation

Install the Kodak TWAIN driver from the installation disk or download the most current driver version.

Citrix Scanner Access Setup

Configure scanner access via Citrix, including granting necessary security permissions for the scanner.

Scanner Configuration for SCEIS

Scan Validation Tool Configuration

Use the Scan Validation Tool to select the TWAIN driver and establish a connection to the scanner.

Scanner Profile Selection and Setup

Choose 'SCEIS Default' or 'Default' profile and configure for double-sided scanning.

General Scanner Settings Configuration

Configure general settings: scan mode, document type, media, resolution, and compression.

Advanced Image Settings Configuration

Adjust advanced image options like two-sided input and combining front/back images.

Scanner Size Settings Configuration

Set document size, image outline, and select predefined paper sizes (e.g., US Letter).

Scanner Adjustments Configuration

Optimize image quality by adjusting contrast, threshold, and applying filters.

Scanner Enhancements Configuration

Configure blank image detection, hole fill, streak filter, and color dropout for document processing.

Device General Settings

Configure device-specific options: paper source, power saver, and document feeder timeout.

Device Multifeed Settings

Set up multifeed detection using ultrasonic and length sensors, including audible alerts.

Saving the SCEIS Scanner Profile

Save the configured settings as a new profile named 'SCEIS Default' for future use.

Final Configuration Check

Verify 'SCEIS Default' is the primary profile and confirm scanner readiness for SCEIS imaging.

Lock Scanner Configuration

Secure Scanner Configuration Files

Make key scanner configuration files read-only to prevent accidental or unauthorized changes to SCEIS settings.