A-61679 May 2015 25
Detect tab The Detect tab provides the following options.
Blank Image Deletion — allows you to configure the scanner to not
give blank images to the scanning application.
• (none): all images are given to the scanning application.
• Based on Document Content: images will be considered blank
based on the document content within the image.
- Content amount: allows you to select the maximum amount of
content that the scanner will consider to be blank. Any image that
has more content than this value will be considered non-blank and
will be given to the scanning application. The values range from 0 to
100 percent.
-: Content amount will be filled in with the amount of content in
the preview image. If you have a representative blank document
(e.g., blank sheet with letter head), this can be used to assist with
determining the setting for Content amount (i.e., perform a preview
scan, click this button, and adjust Content amount as appropriate).
NOTE: This option is only available when there is a preview image.
To Next Page
Loading...
