104 105104
If the camera is not connected to a
PictBridge compatible printer, the
following error message will appear on
the LCD.
Connection Failed!
The error message above will
also appear if the USB mode is
set incorrectly, in which case you
should disconnect the Micro USB
cable, check the USB mode settings,
ensure that the printer is turned on,
and then try connecting the Micro
USB cable again.
1. Make sure the printer is turned on.
2. Connect one end of the supplied Micro
USB cable to the Micro USB port on
your camera.
3. Connect the other end of the cable to
the USB port on the printer.
Connecting to your Printer
To Next Page
Loading...
