39
Flash Mode
The Flash is used to illuminate a subject in low light
or for ll-in lighting to achieve better illumination of a
subject with pronounced shadows.
1. Pop up the ash manually as shown below.
2. Press the right arrow button ( ) to enter the
Flash Settings Menu.
3. Press the left/right to select the following 5 modes:
• Flash Auto
Camera ash goes off automatically based
on existing light conditions.
• Force Flash
The ash will engage with each shot even
if there is enough available light to take the
photo without ash.
• Slow Sync.
This allows for night scenery photos that
include people in the foreground. The use
of a tripod is recommended when shooting
with this setting.
• Slow Sync. + Red-Eye
Use this mode for slow synchro shots with
red-eye reduction.
• Red-Eye Reduction
The camera emits a brief pre-ash before
the picture is taken to reduce red-eye
effects.
4. Press the button to conrm the settings and
exit the option.
To Next Page
Loading...
