Kodak Scanmate i1120 - Page 3

Smart Touch Shortcut Setup
© 2008 Newell Rubbermaid. All Rights Reserved 3
To configure the DYMO File shortcut
1 Be sure the Task Shortcut drop-down list shows the number and name of the DYMO
File shortcut that you are configuring.
2 In the Destination drop-down list, select File.
3 In the File type drop-down list, select PDF.
4 In the Folder field, specify a folder for DYMO File by doing either of the following:
• Use the default path and add \DYMO at the end.
• Click Browse to specify an entirely different path, with \DYMO as the last folder
in the path.
EXAMPLES:
C:\DocumentsandSettings\Tom\MyDocuments\Smarttouch\ill00\Output\DYMO
K:\Smarttouch\DYMO
You can select a folder on either your local computer or a network drive that is shared
by multiple users. Remember this location because each user needs to specify it again
during DYMO File setup, as described beginning on page 5. This is the location where
DYMO File software temporarily saves files, after scanning and before processing.
DYMO File Monitor watches this location for scanned documents that are ready to be
processed.
5 Ensure that the Edit image prior to saving and Name file prior to saving check
boxes are not selected.
Clearing these check boxes eliminates unnecessary prompts during DYMO File
scanning.
NOTE When the Display settings prior to scanning check box is selected, a settings
dialog box appears each time a user presses the scan button. If you don’t want users to
be able to change settings, clear this check box also.
Destination
(Scan to File)
Folder that DYMO File
will monitor
File Type
(PDF)
Ignored by
DYMO File
Browse button
Settings button
Should
not
be selected
Should not
be selected
May be
selected
Shortcut number
and name