Kodak verite 55 plus - Maintenance and Cleaning Procedures; Cleaning Ink Cartridge Nozzles and Contacts; Power Cycling the Unit

English
53
Restoring the factory settings
You can restore the default settings on the unit using the web
interface or Control panel.
»
Refer to “Restore Factory Default” on page 46.
Power cycling
»
Refer to “Troubleshooting” on page 55.
If a problem occurs that cannot be corrected with the instructions in
“Troubleshooting”, follow the Steps given here.
1 Pull out the AC plug.
2 Wait at least 30 seconds, then connect the AC plug back into the
AC outlet.
3 Follow the instructions on the display and in the error report. If the
problem repeats, visit the following website at
www.kodakverite.
com/support
Cleaning the printhead nozzles
•
Using the Control panel
1 From the Control panel, press until [Setup], then press
.
2 Press to select [Maintenance], then press .
3 Press to select [Clean Printhead], then press .
4 Load plain Letter or A4 -size paper.
5 Press to start cleaning the printhead.
6 A page prints, forcing ink through the ink cartridge nozzles to clean
them (this will use up some of your Ink from the Cartridges).
7 Print the document again to verify that the print quality has
improved.
Cleaning the ink cartridge nozzles and contacts
1 Remove the ink cartridge(s).
2 Dampen a clean, lint-free soft cloth with water, and then place the
cloth on a flat surface.
3 Gently hold the nozzles against the cloth for about 3 seconds, and
then wipe in the direction shown.
e.g.) Verité 5 Color CartridgeXL COLOR
4 Using another clean section of the cloth, gently hold the cloth
against the contacts for about 3 seconds, and then wipe in the
direction shown.
e.g.) Verité 5 Color CartridgeXL COLOR
5 With another clean section of the cloth, repeat Step 3 and Step 4,
and then let the nozzles and contacts dry completely.
6 Reinsert the ink cartridge(s), and then print the document again.
7 If the print quality does not improve, clean the print nozzles, and
then try printing the document again.
8 Repeat Step 7 up to two more times.
9 If print quality is still not satisfactory, replace the ink cartridge(s).
Continued on next page.