Koehler KV3000 - Changing Bath Lamp; Bulb; Replacement Parts

KV3000 Kinematic Viscosity Bath
Operation and Instruction Manual
KV3000-Manual
-19-
17. Once the bath jar and top assembly are
clean and dry, re-assemble the instrument
and fill the bath with new medium as per
section 5.1 of this document.
7.4 Changing Bath Lamp / Bulb
1. Using a flat head screwdriver, remove the
four (4) silver screws located at the four
corners of the back panel.
2. Remove the back panel plate and set aside.
3. The lamp / light bulb is located at the top
right cover of the instrument. See Figure 5.
Figure 5. Lamp Location
4. Turning counterclockwise, remove the old
light bulb.
5. Replace with new light bulb and re-
assemble the back plate.
7.5 Replacement Parts
Part Number
Description
050-001-028
Single Pole Switch, 15A
091-032-001
Solid State Relay, 4-32 VDC, 20A
275-103-036
RTD Temperature Safety Limit,
120V
†
275-103-037
RTD Temperature Safety Limit,
230V
‡
278-001-002
Slow-Blow Fuse, 1A, 5x20 mm
278-104-002
Slow-Blow Fuse, 0.25A, 5x20 mm
278-003-001
Slow-Blow Fuse, 3.15A, 5x20mm
‡
278-020-004
Time Delay Fuse, 20A, 600VAC
278-102-003
Fast-Acting Fuse, 0.5A, 2AG
275-103-044
Temperature Controller 100-
240V, with RS-232 Board
279-115-009
Compact Fluorescent, 120V, 15W
379-001-001
Liquid Level Switch
K23700-02003
RTD Assembly
K23700-03024
Moisture Barrier Gasket
K23700-03006
Heater, 115V, 1250W
†
K23700-03015
Heater, 230V, 1250W
‡
K23700-
03013A
Stainless Steel Shaft Motor,
115V, 60Hz, 1/20HP
†
K23700-
03014A
Stainless Steel Shaft Motor,
230V, 50/60W, 1/15HP
‡
090-120-017
DPST Contactor, 120V, 30A
†
090-240-021
DPST Contactor, 240V, 30A
‡
240-230-004
Transformer ‡
092-001-001
Timer
Note:
†
For 115V model ONLY (K23700, K23706)
‡
For 220V model ONLY (K23790, K23796)