What to do if the battery is discharged but the Kohler Inverter charger has power and is operating?
If the battery is discharged, but the Kohler Inverter charger has power and is operating, check the 5-amp fuse F2 (5A-T) inside the battery charger and replace it if necessary. Also, check the inline fuse F4 and replace it if needed.
General| Voltage | 120/240 V |
|---|---|
| Frequency | 60 Hz |
| Power Output | 12, 000 watts |
| Phase | Single |
| Starting System | Automatic |
| Transfer Switch | Optional |
Covers accidental starting, battery hazards, and general safety precautions.
Addresses fuel system dangers, noise exposure, and electrical shock risks.
Details safety for heavy equipment, hot parts, and moving components.
Provides important notices on ESD, voltage, hardware, and Canadian installations.
Explains the generator set nameplate and its importance for service.
Outlines EPA and California emission compliance for the generator sets.
Provides contact information for technical support and service.
Details the generator's voltage regulation and engine features.
Lists the capabilities and indicators of the ADC 2100 controller.
Identifies key components of the generator set via diagrams.
Procedures for ensuring readiness and regular unit operation.
Explains controller interface, starting methods, and stopping procedures.
Details fault conditions, codes, and how to reset the controller.
Covers circuit breakers, fuses, and battery charger functionality.
Guidelines for scheduling and performing routine maintenance tasks.
Procedures for checking oil, oil changes, and filter replacement.
Maintenance for air intake, ignition system, and cooling components.
Inspection of exhaust system and detailed battery maintenance steps.
Maintenance for the battery charger and long-term storage guidelines.
Guides for diagnosing common problems and understanding fault codes.
Addresses specific issues with the controller and battery charger.
Lists model specification numbers and references for wiring diagrams.
Provides the primary schematic wiring diagram for the generator set.
Continues the schematic wiring diagram with more details.
Illustrates the point-to-point wiring connections for the generator set.
Covers overall installation guidelines, unit weight, and initial inspection.
Details safe mounting practices and exhaust system considerations.
Specifies air intake, electrical power, and fuel supply needs.
Procedures for AC load connections, remote start, and battery setup.
Covers installation of accessories and controller setup options.
Final checks before startup and warranty registration process.
To Next Page
