TP-6196 10/09 13Section 1 Specifications
Section 1 Specifications
1.1 Introduction
The spec sheets for each generator set provide specific
generator and engine information. Refer to the
generator set spec sheet for data not supplied in this
manual. Consult the generator set installation manual,
engine operation manual, and engine service manual
for additional specifications.
Check the generator set nameplate for specific
generator set ratings.
1.2 Controller Specifications
For a specific description of the controller, see
Section 2, Operation, in the operation manual.
Environmental S pecifications
Operating temperature
--20" to 70"C
Storage temperature
--60" to 70"C
Humidity 0--95% condensing
Power requirements:
Voltage 12 or 24 VDC
Current
250 mA @ 12 VDC
125 mA @ 24 VDC
1.3 E ngine Features
The generator sets are equipped with four-cycle, twin
cylinder, air-cooled Kohler engines. Some of the engine
features include:
! One-side serviceability of air cleaner, carburetor, oil
fill, dipstick, and oil drain.
! Efficient overhead valve design and full pressure
lubrication for maximum power, torque, and reliability
under all operating conditions.
! Electronic governor to ensure AC power output is
maintained at desired frequency.
! Overspeed shutdown to prevent governed frequency
from exceeding 70 Hz on 60 Hz models (60 Hz on
50 Hz models).
! Low oil pressure cutout to prevent failure.
! Dependable, maintenance free electronic ignition.
! Digital Spark Advance Ignition (DSAI) optimizes
engine timing for natural gas or LP fuel (12 kW models
only).
! Parts subject to the most wear and tear made from
precision formulated cast iron.
! Hydraulic valve adjusters to eliminate the need for
valve adjustments.
! Field-convertible fuel systems that allow fuel
changeover from natural gas to LP vapor (and
vice-versa) while maintaining CARB certification.
For engine service information and specifications not
covered in this manual, see the Engine Service Manual.
To Next Page
Loading...
Need help?
General
