Controller
Display
Message
Fault
Lamp
Warning
Shutdown
Write
Access
Display
SiteTech
GenSet
Mode
Always
Running
Stopped
Default
Time
Delay
(sec.)
Default parameters loaded
Enclosure temperature: high
shutdown
Enclsr Temp:
High Shutdwn
Engine cooldown (delay)
active
Engine start delay active
File system error (controller
fault)
Input/output (optional module
board) communication loss
Measurement Units, 0-English,
1-Metric
Metering communication loss
Not in auto (master control
buttons)
Prime power application,
0-Standby, 1-Prime
* Function requires optional input sensors or is engine ECM dependent on some generator set models.
† ECM inputs are engine-manufacturer dependent.
‡ Changeable only by resetting the controller with a personality profile (SiteTech 1.4 or higher).
** Denotes the default parameter range. Typically, ranges for the NiCad battery topology are slightly wider. For more details, refer to the
battery charger operation manual.
ST- Short Term, LT- Long Term