12. Clean the Inlet Screens
Disconnect the power and turn off the water supply.
Disconnect the removable pipe segment.
Remove the screws and inlet clamp.
Remove the adapters from the valve inlets.
Gently pull the check valves from the valve inlets.
Remove the screens from the check valves.
Clean the screens to remove any dirt or debris.
Rinse or replace the check valves and screens.
Reassemble the inlet connections.
Troubleshooting
WARNING: Risk of electric shock. Disconnect power before servicing.
CAUTION: Risk of personal injury. The valve may contain hot water; be careful when draining
any residual water.
NOTICE: Valve maintenance should be performed by a KOHLER Authorized Service Representative.
NOTE: For service parts information, visit your product page at www.kohler.com/serviceparts.
This troubleshooting guide is for general aid only. For service and installation issues or concerns, call
1-800-4KOHLER.
O-Ring
Screw
Inlet Clamp
Removable
Pipe Segment
Union Connection
Adapter
Check Valve
Screen
1043183-2-E 18 Kohler Co.
To Next Page
Loading...
Need help?
General
