Kohler KD350 - Refitting Gear Cover On Timing Side; Speed Governor; Speed Governor Removal

79
80
81
DISASSEMBLY/REASSEMBLY
8
- 45 -
Speed governor
Components:
1Spoolspacer
2Spool
3Weights
4Spoolguide
5Gear
6 Oilpumpdrivingshaft
7Circlip
8Thrustring
Speed governor removal
Spoolguide1hasretainersoneendwhichpreventspool2fromslip-
pingout.
To remove the speed governor use a suitable tool to slightly widen
thetwoteeth.
Retting gear cover on timing side
Propersealingbetweengearcoverandcrankcaseisensuredbythe
liquidsealant"Loctite5205".Carefullycleanthetwosealingsurfaces
andspreadthesealantuniformly.
Tightenscrewsto23Nm.
Wait3 hoursbeforestartingtheengine.
KD 225_315_350_400_440 Workshop Manual_cod. ED0053029330_1° ed_ rev.00