Kohler RSB Series - Load Shed Kit

TP-6487 8/07 25Section 4 Accessories
4.2 Load Shed Kit
The optional load shed kit disconnects selected loads
before transfer to the emergency source, reducing the
load on the generator set. See Section 2 for descriptions
of the load shed operation during normal operation, test
and exercise.
Transfer switches that are factory-equipped with the
load shed accessory have a letter S at the end of the
model designation. See the model code chart in the
Introduction.
TP-6486
1. Circuit breaker interface modules
1
Figure 4-4 Type 1 Enclosure with Two Load Shed
Modules
The load shed kit includes one or two load shed modules
which connect to remote-controlled branch circuit
breakers (sold separately). Type 1 enclosures can have
one or two load shed modules installed. Type 3R
enclosures can have one load shed module installed.
Up to 6 one- or two-pole circuit breakers can connect to
each module. See Figure 4-4 and Figure 4-5 for the
load shed module location.
TP-6486
1. Circuit breaker interface module
1
Figure 4-5 Type 3R Enclosure with One Load Shed
Module