Why is the cutting quality of my Kolbe Kitchen Appliances mincer deteriorating?
A deterioration in cutting quality can be attributed to high cutting set wear. To resolve this, regrind or replace the perforated discs and cross knife, or replace the cutting blades. Other solutions include fitting a new mincer worm, fitting a new mincer worm and casing, or replacing the knife journal.
What to do if Kolbe TW 98 Kitchen Appliances mincer worm blocks and the drive motor hums?
If the mincer worm blocks and the drive motor hums, immediately switch off the mincer and remove the blockage in the mincer worm. You can also try to allow the motor to cool, then switch on again, or remove the blockage in the mincer and allow the motor to cool.
How to fix Kolbe TW 98 mincer that cannot be switched on?
If the mincer cannot be switched on, it might be because the thermal contacts in the motor or the over current relay in the controller have been activated, effectively switching off the mincer. Try inserting the mains plug or allow the motor to cool, then switch it on again.
General| Brand | Kolbe |
|---|---|
| Model | TW 98 |
| Category | Kitchen Appliances |
| Language | English |
To Next Page