Kolbe TW 98 - Troubleshooting

9
10. Troubleshooting
Faults Cause Remedy
The mincer cannot be switched on
The thermal contacts in the motor or the
over current relay in the controller have
been activated, in other words, the mincer
has been switched off
The mincer worm blocks and the drive
motor hums other
Deterioration in cutting quality
High cutting set wear
Mincer caused loud noises
- Insert mains plug
- Call an electrician
- Replace fuses (call an
electrician)
- Allow the motor to cool then
switch on again
- Call an electrician or customer
service
- Call an electrician or customer
service
- Allow the motor to cool, then
switch on again
- Remove the blockage in the
mincer, allow the motor to cool
- Call an electrician
- Switch off the mincer immediately
and remove the blockage in the
mincer worm
- Regrind or replace perforated
discs and cross knife or replace
cutting blades
- Fit new mincer worm
- Fit new mincer worm and new
mincer casing
- Replace knife journal
- Fit new mincer worm and new
mincer casing
- Call customer service
- Call customer service