7
Step 2
Attach the window slider kit to the window sill. Adjust the length of the window slider kit
according
to the
width of the window. Use the window slider “bolt” to secure the slider to the
correct width. Open the window sash and place the window slider kit on the window sill then
close the window sash securely against window slider kit.
Step 3
Cut the foam seal to an appropriate length and seal the open gap between the top window sash
and outer window sash.
Step 4
If desired, secure the security bracket to the window frame. When installed properly, the
bracket will prevent the window sash from being opened.
Note: If needed, you may trim the adjustable window kit if the width of the window is less than
26.5”.
To Next Page
Loading...
