14
Timer
When the unit is on, press the timer button to initiate the Auto-off stop program, the TIMER OFF
indicator light will illuminate. Press the < or > button to select the desired time. Press the TIMER
button again within five seconds, the Auto-on start program is initiated and the TIMER ON
indicator light will illuminate. Press the < or > button to select the desired Auto-on start time.
When the unit is off, press the TIMER button to initiate the Auto-on start program, press it again
within five seconds and the Auto-off stop program will initiate.
Press or hold the < or > button to change the Auto time by 0.5 hour increments, up to 10 hours,
then at 1 hour increments up to 24 hours. The control will count down the time remaining until
the unit starts. The system will automatically revert back to display the previous temperature
setting if no button is pressed within five seconds.
Sleep
Select to initiate the SLEEP / ECO operation. The selected temperature will increase (cooling) by
1°C / 1°F 30 minutes. The temperature will then increase (cooling) by another 1° C / 1° F after an
additional 30 minutes. This new temperature will be maintained for 7 hours before it returns to the
originally selected temperature. This ends the Sleep / Eco mode and the unit will continue to
operate as originally programmed.
Note: This feature is unavailable under FAN or DRY mode.
Increase / Decrease
These buttons are used to increase or decrease the temperature settings (1º C / 2º F increments)
in a range of 17º C (62º F) to 30º C (88º F) or the TIMER setting in a range of 1-24 hrs.
The control panel is capable of displaying the temperature in Fahrenheit or Celsius. To convert
from one to the other, press and hold the UP and DOWN buttons at the same time for 3 seconds.
Fan Indicator Lights
Press to select the fan speed in four settings- LOW, MED, HIGH, and AUTO. The fan speed
indicator light illuminates according to the fan setting that is selected.
To Next Page
Loading...
Need help?
General
