-13-
finishing the self-test, the UPS will get into the inverter mode, at
this time, the LCD screen will light up and indicate the state of the
UPS.
(2) Without utility power connecting:
Even though utility power is not connected to the UPS, the UPS
still can be turned on by just simply pressing “I” button
continuously for more than 1 second. Then the UPS will get into
self-test status first. After having finishing the self-test, the UPS
will get into the inverter mode, at this time, the LCD screen will
light up and indicate the state of the UPS.
Note: The default setting for bypass mode is no output after UPS
is connecting utility power and breaker is turned on. This can be
configured by monitoring the LCD panel or firmware.
5.5 Test Function:
Test the function of the UPS system by either pressing the “On”
button or disconnecting the input of the UPS system from the power
supply.
5.6 Turn Off the UPS:
(1) In Inverter Mode:
Press “OFF” button continuously for more than 1 second to turn off
the UPS. Then the UPS will get into self-test status first. After
having finished the self-test, the UPS will get into no output or
bypass mode. At this time, the UPS might has output if bypass is
enabled. Disconnect the utility power to turn off the output.
(2) In Battery Mode:
Press “OFF” button continuously for more than 1 second to turn off
the UPS. Then the UPS will get into self-test status first. After
having finished the self-test, the UPS will be turned off completely.
To Next Page
Loading...
