Kolin Quad Series - Page 18

LCD displays " ". Press the button for the second time to start health and
scavenging functions simultaneously; LCD displays " " and " ". Press this
button for the third time to quit health and scavenging functions simultaneously.
Press the button for the fourth time to start health function; LCD display " ".
Press this button again to repeat the operation above.
Press "WiFi" button to turn on WiFi function, "WiFi" icon will be displayed on the
● This function is only available for some models.
remote controller;
Hold "WiFi" button for 5s to turn off WiFi function and "WiFi" icon will disappear.
Under off status, press "MODE" and "WiFi" buttons simultaneously for 1s, WiFi
module will restore factory settings.
Function introduction for combination buttons
-15 -
the lamp is defaulted on.
simultaneously to set the lamp on or off and send the code. After being energized
Under switch-on or switch-off state, you may hold "+"and "FAN" buttons
Light function
erature display between °C and °F
Under OFF status, press "-" and "Mode" buttons simultaneously to switch temp-
Temperature display switchover function
Press this button to turn on or turn off the health and scavenging functions in
8
Health button
timer.
status will disengage after 5s.If timer is confirmed, press this button again to cancel
If the characters are flashing but you haven’t press the timer button, timer setting
HOUR ON(OFF) will stop flashing.
0.5~24hours. Press this button again to confirm timer setting and the characters of
(timewill change quickly if holding “+” or “-” button). Time setting range is
remote display. Meanwhile, press “+” button or “-” button to adjust timer setting
Press this button once and the characters of HOUR ON (OFF) will flash on the
this button to set timer ON.
Under ON status, press this button to set timer OFF; Under OFF status, press
7
Timer button
9
WiFi button
●This function is only available for some models.