DS4 C
HAPTER
2 - I
NSTALLATION
2-1
C
HAPTER 2
I
NSTALLATION
2.1 INTRODUCTION
The information in this chapter will familiarize you
with the safety information, unpacking and
inspection, installation requirements, assembly
procedures and electrical connections for installing
the BDS4. A checklist is provided at the end of this
chapter to insure proper installation.
2.2 SAFETY INFORMATION
The purpose of this section is to alert you to possible
safety hazards associated with this equipment and the
precautions you can take to reduce the risk of
personal injury and damage to the equipment.
Safety notices in this manual provide important
information. Read and be familiar with these
instructions before attempting installation, operation,
or maintenance. Failure to observe these precautions
could result in serious bodily injury, damage to the
equipment, or operational difficulty.
The safety-alert symbols are illustrated in Figure 2.1.
When you see these symbols in this manual, be alert
to the potential for personal injury. Follow the
recommended precautions and safe operating
practices included with the alert symbols.
"
Warning
" refers to personal safety. They alert you
to potential danger or harm. Failure to follow
warning notices could result in personal injury or
death.
"
Caution
" directs attention to general precautions,
which if not followed, could result in personal injury
and/or equipment damage.
"
Note
" highlights information critical to your
understanding or use of these products.
2.3 CONVENTIONS
To assist you in understanding the material in this
manual, conventions have been established to
enhance reader comprehension. Explanations of
these conventions are as follows:
•
Safety warnings, cautions, and notes present
material that is important to user safety. Be sure
to read any safety notices you see as they could
prevent equipment damage, personal injury, or
even death to you or a co-worker.
• Bold
text highlights other important information
that is critical to system operations.
WARNING CAUTION NOTE
Figure 2.1. Safety-Alert
Symbols
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
