Komatsu 80001 - Page 45

00 Index and foreword SEN03766-02
PC130-8
31
Type 3
1. Disconnection
1) Hold the tightening portion and push body
(9
) straight until sliding prevention ring (8)
contacts contact surface (b) of the hexag-
onal portion at the male end. (Fig. 10)
2) While holding the condition of Step 1),
p
u
sh cover (10) straight until it contacts
contact surface (b) of the hexagonal por-
tion at the male end. (Fig. 11)
3) While holding the condition of Steps 1)
and 2
)
, pull out whole body (9) to discon-
nect it. (Fig. 12)
2. Connection
q Hold the tightening portion and push body
(9) straight until the sliding prevention ring
contacts contact surface (b) of the hexag-
onal portion at the male end. (Fig. 13)