Komatsu D51EXi-24 - Control Point Files; Method for Importing Control Point Files

7.
Select 1 file, and press
“Rename”.
You can rename the selected file and export it under a dif-
ferent name.
8.
Input the new filename, and press “Ok”.
9.
Press “Ok” and export the file.
The screen returns to “Project Files”
screen.
CONTROL POINT FILES
The control point files (*.gc3) contain the control points (coordinates of N, E, and elevation) and localization data
(coordinates of latitude, longitude, and elevation).
The control point files are necessary to 3DMC and usually are contained in the project files. You can read the
control point files individually from USB memory or internal memory of the control box to 3DMC.
METHOD FOR IMPORTING CONTROL POINT FILES
When importing a control point file, perform the following procedure.
AJD02563
AJD02564
AJD02565
HANDLE CONTROL BOX FILE MENU
4-13