12. OPERATION
12.2.2 STARTING IN COLD WEATHER
When starting in low temperatures, do as follows.
a
WARNING
Never use starting aid fluids as they may cause explosions.
NOTICE
Do not keep the engine rotating for more than 20 seconds.
If the engine does not start, wait for at least 2 minutes, then
repeat Steps 2 and 3.
1. Move fuel control lever @ to a position midway between the
engine stop position and the high idling position.
AE081040
Engine stop
\
AE080240
2. Turn the key in the starting switch @to the HEAT position and
hold it until heater signal @ glows red.
The preheating times are as shown below.
-10°C - -20°C
Approx. 30 seconds
Always use the correct preheating time. If the preheating time is
too long or too short, the engine will not start easily.
3. When heater signal @ glows red, turn the key in the starting
switch @ to the START position and start the engine.
REMARK
After carrying out warming-up operation, travel at low speed and
gradually apply the load.
START
AE077513
2-25
To Next Page