2-56
PC210/240-ENG
7. Turn fuel control dial a to the full speed (MAX) position and carry
out the operation is Step 6 for 3 -5 minutes.
8. Repeat the following operation 3 - 5 times and operate slowly.
• Boom operation RAISE vn LOWER
• Arm operation IN vn OUT
• Bucket operation CURL vn DUMP
• Swing operation LEFT vn RIGHT
• Travel (Lo) operation FORWARD vn REVERSE
REMARK
If the above operation is not carried out, there may be a delay in
response when starting or stopping each actuator, so continue the op-
eration until it becomes normal.
9. Use working mode switch b on the monitor panel to switch to the
working mode to be used.
12. OPERATION
H/O G/O F/O L/O B/O
To Next Page
Loading...
