Komatsu PC210 User Manual

2-82
PC210/240-ENG
12.20 CHECK AFTER STOPPING ENGINE
1. Walk around the machine and check the work equipment, paintwork,
and undercarriage, and check also for leakage of oil or water. If any
abnormalities are found, repair them.
2. Fill the fuel tank.
3. Check the engine compartment for paper and debris. Clean out any
paper and debris to avoid a fire hazard.
4. Remove any mud stuck to the undercarriage.
12.21 LOCKING
Always lock the following places.
a Door of operator’s cab
Always remember to close the window.
b Fuel tank filler port
c Engine hood
d Battery box cover
e Left side door of the machine
f Right side door of the machine
REMARK
Use the starting switch key to open and close all these places.
12.22 OVERLOAD WARNING DEVICE
❇ Excavators are provide and with this device to warm the operator
about tipping over while lifting loads. A buzzer will sound when the
machine is in Lo mode and the machine nears its lifting capacity.
NOTE
Only conduct lifting operations in Lo mode as the overload warning
system is only active in this mode.
12. OPERATION
e

Komatsu PC210 Specifications

General

Bucket Capacity	0.8 - 1.2 m³
Travel Speed	5.5 km/h
Max Digging Depth	6, 620 mm
Max Reach	9, 850 mm
Fuel Tank Capacity	400 l
Engine Model	Komatsu SAA6D107E-1