EasyManua.ls Logo

Komatsu PC210 - Battery

Komatsu PC210
266 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1-16
PC210/240-ENG
7. PRECAUTIONS DURING OPERATION
7.4 BATTERY
BATTERY HAZARD PREVENTION
Battery electrolyte contains sulphuric acid and can quickly burn the skin and eat holes in clothing. If you spill
acid on yourself, immediately flush the area with water.
Battery acid could cause blindness if splashed into the eyes. If acid gets into the eyes, flush them immedi-
ately with large quantities of water and see a doctor at once.
If you accidentally drink acid, drink a large quantity of water or milk, beaten egg or vegetable oil. Call a
doctor or poison prevention centre immediately.
When working with batteries. ALWAYS wear safety glasses or goggles.
Batteries generate hydrogen gas. Hydrogen gas is very EXPLOSIVE, and is easily ignited with a small
spark or flame.
Before working with batteries, stop the engine and turn the starting switch to the OFF position.
Avoid short-circuiting the battery terminals through accidental contact with metallic objects, such as tools,
across the terminals.
When removing or installing, check which is the positive (+) terminal and negative (-) terminal.
Tighten the battery cap securely.
Tighten the battery terminals securely. Loosened terminals can generate sparks and lead to an explosion.
When removing battery cap wear rubber groves to prevent electrolyte contact with skin.
STARTING WITH BOOSTER CABLES
ALWAYS wear safety glasses or goggles when starting the machine with booster cables.
When starting from another machine, do not allow the two machines to touch.
Be sure to connect the positive (+) cable first when installing the booster cables. Disconnect the ground or
negative (-) cable first when removing them.
If any tool touches between the positive (+) terminal and the chassis, it will cause sparks. This is dangerous,
so be sure to work carefully.
Connect the batteries in parallel: positive to positive and negative to negative.
When connecting the ground cable to the frame of the machine to be started, be sure to connect it as far as
possible from the battery.
Starting with booster cables n See 16.5 “IF BATTERY IS DISCHARGED.”
WARNING: For reasons of safety, al-
ways follow these safety precautions.
INCORRECT

Table of Contents

Related product manuals