3-66
PC210/240-ENG
24.8.2 CLEAN HYDRAULIC TANK STRAINER
The oil is at high temperature immediately after the machine
has been operated. Wait for the oil to cool down before clean-
ing the strainer. When removing the oil filler cap, turn it slowly
to release the internal pressure, then remove it carefully.
1. Loosen 4 bolts, then remove cover a.
When doing this, the cover may fly out under the force of spring b,
so push the cover down when removing the bolts.
2. Pull up the top of rod c, and remove spring b and strainer d.
3. Remove the dirt stuck to strainer d, then wash it in clean diesel oil or
flushing oil.
If strainer d is damaged, replace it with a new one.
4. Refit strainer d by inserting it into tank projecting part e.
5. Install cover a with bolts.
WARNING
24. SERVICE PROCEDURE
To Next Page